Price range: $8,99 through $335,82 VAT where applicable
Practice snowboard butters, presses and spins without snow. Build your own training area with interlocking 20 × 20 cm SnowGrid tiles.
Choose a complete setup: Starter 140 × 140 cm or Full Size 200 × 200 cm. Expansion packs and single tiles extend an existing setup.
SNOWGRID / SNOWBOARD TRAINING
Your own snowboard. A dedicated training spot. SnowGrid’s interlocking tiles create a sliding surface for butters, presses, spins and flatground practice — without waiting for winter.
Build a setup for your space, repeat individual movements and work towards linking them together.
Work on board control, balance and trick combinations at home, in the garden or in a suitable training space. Leave enough clearance around and above you for every movement.
Start with individual movements, repeat them and gradually link them together. SnowGrid is a training surface, not a protective landing mat.
TWO COMPLETE SETUPS
Both setups use the same 20 × 20 cm tiles. Choose for your available space, snowboard length and the movements you want to practise.
140 × 140 cm · 49 tiles · 1.96 m²
A compact setup for smaller spaces and focused ground-trick practice. Check your board length and allow enough room for your intended movements.
200 × 200 cm · 100 tiles · 4 m²
The recommended starting point for most adult snowboard setups. More than twice the surface area of Starter, with more room for rotations, combinations and full-size boards.
MODULAR BY DESIGN
Every 20 × 20 cm module connects with the surrounding tiles. Extend your training area, change its layout or replace one section instead of the whole mat.
Expansion packs and single tiles extend an existing SnowGrid installation. They are not complete training areas.
Install on a flat, level, stable surface. The assembled tiles must be fully supported and remain stationary. Suitable spaces can include short, level grass on firm, even ground or a suitable flat carpeted surface.
Indoors, use suitable full-area floor protection. Check the complete setup for stability and leave clear space around and above the rider.
SnowGrid can be used dry. For increased glide, lightly sprinkle with water only where the installation and underlying surface are suitable for wet use.
Use only a lubricant confirmed as compatible with SnowGrid and your snowboard base. Keep surrounding walking areas dry and adjust your movements to the increased glide.
BEFORE YOUR FIRST SESSION
Starter measures 140 × 140 cm and suits compact spaces. Full Size measures 200 × 200 cm and is recommended for most adult snowboard setups. Measure your board and available space, including clearance for your intended movements.
Yes. All SnowGrid configurations use compatible interlocking tiles. Add a 10-tile Expansion pack or individual tiles to extend or adjust an existing installation.
No. SnowGrid is a sliding training surface. Wear a helmet and appropriate protection, inspect tiles and connections before use and follow the safety instructions. Children require direct adult supervision. Do not use it for flips, elevated jumps or unapproved rails and obstacles.
Dull, burr-free edges are recommended. Board and floor damage may occur during training. Inspect your equipment and remove plastic shavings from the training area.
Dry use is possible. Lightly sprinkle with water only on an installation suitable for wet use. Keep surrounding floors dry and do not use unapproved lubricants.
| Weight | N/A |
|---|---|
| Dimensions | N/A |
| Options | Expansion, Full Size, Single Tile, Starter |
| Material | RDS |
| Tile size | 20 × 20 cm |
| Overall tile height | 3.5 cm / 35 mm |
| Construction | Modular, interlocking tiles |
| Colour | White |
| Intended use | Snowboard butters, presses, spins and flatground training |
| Expansion compatibility | Compatible with all Switch SnowGrid configurations |
Jakub Pacut Fabryczna 10 43-440 Goleszów, Poland, [email protected]
